Tank & Enclosure System

WAZER’s Tank and Enclosure System contains the Cut Bed and has the difficult task of keeping all the water and abrasive contained and supported.

Leveling the Cut Bed

Having a level Cut Bed is critical. The height of the Nozzle needs to be consistent at every point on the Cut Bed. If it isn’t, this can result in Partial Cutting, a Cut failure, or damage to WAZER.

Door Switch Magnet Adjustment

If the Wazer Displays a “Close Door” error despite the door being closed, the door window magnet likely needs to be adjusted.

Cleaning the Pump Box Air Filter

The pump box Air filter needs to be cleaned roughly every 300 hours. If the Wazer is located in a particularly dusty area it should be checked and cleaned more often.  A clean air filter allows the the pump box to run far cooler, prolonging the life of all the components inside


[WARNING] WAZER DOES NOT track the number of hours it has been running.
To ensure a safe and reliable machine, you MUST track your WAZER's run time so that you may perform preventative maintenance as required in this User Manual. If you do not abide by the regular maintenance procedures and schedule, the warranty and support for your WAZER will be void.

Before servicing WAZER:

  • Purge the high-pressure system by properly ending/completing a cut or performing a Nozzle Purge.

  • Turn off or close the On/Off Valve or water supply to the machine.

  • Turn off WAZER and disconnect AC power from WAZER and the Pump Box.

  • Never remove the cover of the Pump Box while it is plugged in.